The process is extremely simple. Really, it’s not any different from normal charging. Simply plug your battery, wait for the flashing red light to disappear and leave it charging for a few more hours than usual. That should kick it off hibernation mode. Like I said, most if not all drones use LiPo batteries.
That will help you determine if the issue is related to the firmware or hardware. This is the issue, the copter itself works fine and all system ok, The camera is not the original one, It´s intended to be for the PH3 A. so I think this is the problem. Not sure about the camera if this works or not.
Aug 19, 2015. #1. First time I updated to Go app it would only allow me to enter camera view for a Phantom 3 Standard, see screen shot, even though I don't have a Phantom 3. and I am sitting in front of my Inspire which is linked to TX as I can still start motors and tilt camera. I downloaded (Inspire) app from DJI site.
PhantomPilots is the leading online community for DJI Phantom drone enthusiasts and a member of the Drone Pilots Media Network. With over 6 million unique drone enthusiasts each year, we offer an incredible opportunity to promote your drone-related products or services.
Hi All, am also having the same problem, assistant software refuses to see the controller. Have installed DJI WIN drivers and the PC recognises the DJI controller as a USB device which discounts the usb cable as being a problem. interestingly the RC Assistant Software V1.1 sees the controller and shows full detail on control stick movements.
You most likely powered down the Phantom before stopping video recording. All you need to do is to put the Micro SD card back in the Phantom camera, then power up the Phantom (remove your propellers before hand in case you inadvertently start them turning. Wait for about 60 seconds then power down.
8SwUBa. 323 14 585 621 218 207 133 534
dji phantom camera not working
